As seen in a previous post I also decided to readdress the design of the foot so as to create a more functional piece directly suited to the needs of the component and the system as a whole. After the pieces were cut using the laser cutter I then assembled them to create the foot piece which attaches to the bottom of the original leg component, creating a sort of sleeve effect. The rods will receive some sort of an attachment, which is still to come, as well as a red rubber capping to finish the end which is not touching the ground surface.
As seen in a previous post I also decided to readdress the design of the foot so as to create a more functional piece directly suited to the needs of the component and the system as a whole. After the pieces were cut using the laser cutter I then assembled them to create the foot piece which attaches to the bottom of the original leg component, creating a sort of sleeve effect. The rods will receive some sort of an attachment, which is still to come, as well as a red rubber capping to finish the end which is not touching the ground surface.
No comments:
Post a Comment